AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Notice of proposed rulemaking (NPRM).
SUMMARY:
The FAA proposes to adopt a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG Trent 1000-A, Trent 1000-A2, Trent 1000-AE, Trent 1000-AE2, Trent 1000-C, Trent 1000-C2, Trent 1000-CE, Trent 1000-CE2, Trent 1000-D, Trent 1000-D2, Trent 1000-E, Trent 1000-E2, Trent 1000-G, Trent 1000-G2, Trent 1000-H, Trent 1000-H2, Trent 1000-J2, Trent 1000-K2, and Trent 1000-L2 model turbofan engines. This proposed AD was prompted by the manufacturer identifying 38 low-pressure compressor (LPC) front cases that have non-optimal properties that could inhibit their ability to contain certain engine failures. This proposed AD would require removing the LPC front case from service and replacing it with a part eligible for installation. The FAA is proposing this AD to address the unsafe condition on these products.
DATES:
The FAA must receive comments on this proposed AD by June 15, 2020.
ADDRESSES:
You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
- Federal eRulemaking Portal: Go to https://www.regulations.gov. Follow the instructions for submitting comments.
- Fax: 202 493 2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12 140, 1200 New Jersey Avenue SE, Washington, DC 20590.
- Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this NPRM, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, 15827 Blankenfelde-Mahlow, Germany; phone: +49 (0) 33 708 6 0; email: https://www.rolls-royce.com/contact-us.aspx. You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7759.
Examining the AD Docket
You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0424; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The street address for Docket Operations is listed above. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT:
Stephen Elwin, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7236; fax: 781-238-7199; email: stephen.l.elwin@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2020-0424; Project Identifier MCAI-2019-00130-E” at the beginning of your comments. The FAA specifically invites comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. The FAA will consider all comments received by the closing date and may amend this NPRM because of those comments.
Except for Confidential Business Information as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to https://www.regulations.gov, including any personal information you provide. The FAA will also post a report summarizing each substantive verbal contact received about this NPRM.
Confidential Business Information
Confidential Business Information (CBI) is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this NPRM contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this NPRM, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as “PROPIN.” The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this NPRM. Submissions containing CBI should be sent to Stephen Elwin, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803. Any commentary that the FAA receives which is not specifically designated as CBI will be placed in the public docket for this rulemaking.
Discussion
The European Union Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2019-0286, dated November 26, 2019 (referred to after this as “the MCAI”), to address the unsafe condition on these products. The MCAI states:
Engineering analysis has identified that 38 LPC front cases have non-optimal material properties. This could inhibit the intended function of the LPC front case to contain certain engine failures. This condition, if not corrected, could, in case of fan blade failure, lead to high energy debris release, possibly resulting in damage to, and reduced control of, the aeroplane.
To address this potential unsafe condition, Rolls-Royce developed an updated life management and issued the NMSB, identifying those ESN that have an affected part installed, and providing the corresponding limit (date) for in-shop front fan case replacement. For the reason described above, this [EASA] AD requires removal from service of the affected engines to replace the affected parts. This [EASA] AD also prohibits re-installation of affected parts.
You may obtain further information by examining the MCAI in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0424.
Related Service Information Under 1 CFR Part 51
The FAA reviewed Rolls-Royce Alert Non-Modification Service Bulletin (NMSB) Trent 1000 72-AK294, dated July 16, 2019. The NMSB contains the serial numbers of the affected LPC front cases, the engine serial number on which these LPC front cases are installed, and the date to remove each engine from service. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
FAA's Determination
This product has been approved by EASA and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. The FAA is proposing this AD because it evaluated all the relevant information provided by EASA and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.
Proposed AD Requirements
This proposed AD would require removing the LPC front case from service and replacing it with a part eligible for installation.
Costs of Compliance
The FAA estimates that this proposed AD affects three engines installed on airplanes of U.S. registry.
The FAA estimates the following costs to comply with this proposed AD:
Action | Labor cost | Parts cost | Cost per product | Cost on U.S. operators |
---|---|---|---|---|
Remove and replace the LPC front case | 390 work-hours × $85 per hour = $33,150 | $1,238,654 | $1,271,804 | $3,815,412 |
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a “significant regulatory action” under Executive Order 12866,
(2) Will not affect intrastate aviation in Alaska, and
(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
- Air transportation
- Aircraft
- Aviation safety
- Incorporation by reference
- Safety
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):
Rolls-Royce Deutschland Ltd & Co KG (Type Certificate previously held by Rolls-Royce plc): Docket No. FAA-2020-0424; Project Identifier MCAI-2019-00130-E.
(a) Comments Due Date
The FAA must receive comments by June 15, 2020.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all Rolls-Royce Deutschland Ltd & Co KG (Type Certificate previously held by Rolls-Royce plc) Trent 1000-A, Trent 1000-A2, Trent 1000-AE, Trent 1000-AE2, Trent 1000-C, Trent 1000-C2, Trent 1000-CE, Trent 1000-CE2, Trent 1000-D, Trent 1000-D2, Trent 1000-E, Trent 1000-E2, Trent 1000-G, Trent 1000-G2, Trent 1000-H, Trent 1000-H2, Trent 1000-J2, Trent 1000-K2, and Trent 1000-L2 model turbofan engines.
(d) Subject
Joint Aircraft System Component (JASC) Code 7230, Turbine Engine Compressor Section.
(e) Unsafe Condition
This AD was prompted by the manufacturer identifying 38 low-pressure compressor (LPC) front cases, part number (P/N) KH26266 with individual serial numbers (S/Ns), that have non-optimal properties that could inhibit their ability to contain certain engine failures. The FAA is issuing this AD to prevent failure of the LPC front case when subjected to high-energy debris release. The unsafe condition, if not addressed, could result in uncontained release of high-energy debris, damage to the engine, and damage to the airplane.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Required Actions
After the effective date of this AD, no later than the required removal date specified in Appendix 1 of Rolls-Royce Alert Non-Modification Service Bulletin (NMSB) Trent 1000 72-AK294, dated July 16, 2019 (“Rolls-Royce Alert NMSB Trent 1000 72-AK294”):
(1) Remove LPC front case, P/N KH26266 and with a S/N identified in Appendix 1 of Rolls-Royce Alert NMSB Trent 1000 72-AK294, and
(2) Replace the LPC front case with a part eligible for installation.
(h) Alternative Methods of Compliance (AMOCs)
(1) The Manager, ECO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ECO Branch, send it to the attention of the person identified in paragraph (i)(1) of this AD. You may email your request to: ANE-AD-AMOC@faa.gov.
(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(i) Related Information
(1) For more information about this AD, contact Stephen Elwin, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7236; fax: 781-238-7199; email: stephen.l.elwin@faa.gov.
(2) Refer to European Union Aviation Safety Agency (EASA) AD 2019-0286, dated November 26, 2019, for more information. You may examine the EASA AD in the AD docket on the internet at https://www.regulations.gov by searching for and locating it in Docket No. FAA-2020-0424.
(3) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, 15827 Blankenfelde-Mahlow, Germany; phone: +49 (0) 33 708 6 0; email: https://www.rolls-royce.com/contact-us.aspx. You may view this referenced service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7759.
Issued on April 23, 2020.
Lance T. Gant,
Director, Compliance & Airworthiness Division, Aircraft Certification Service.
[FR Doc. 2020-09017 Filed 4-29-20; 8:45 am]
BILLING CODE 4910-13-P