(a) Fired pressure vessels (boilers) shall be equipped with water level gauges, pressure gauges, automatic pressure-relief valves, blowdown piping, and other safety devices approved by the American Society of Mechanical Engineers to protect against hazards from overpressure, flameouts, fuel interruptions and low water level, all as required by the appropriate sections, chapters and appendices listed in paragraphs (b) (1) and (2) of this section.

(b) These gauges, devices and piping shall be designed, installed, operated, maintained, repaired, altered, inspected, and tested by inspectors holding a valid National Board Commission and in accordance with the following listed sections, chapters and appendices:

(1) The ASME Boiler and Pressure Vessel Code, 1977, Published by the American Society of Mechanical Engineers.

Section and Title

I   Power Boilers.

II   Material Specifications—Part A—Ferrous.

II   Material Specifications—Part B—Non-ferrous.

II   Material Specifications—Part C—Welding Rods, Electrodes, and Filler Metals.

IV   Heating Boilers

V   Nondestructive Examination

VI   Recommended Rules for Care and Operation of Heating Boilers

VII   Recommended Rules for Care of Power Boilers

(2) The National Board Inspection Code, a Manual for Boiler and Pressure Vessel Inspectors, 1979, published by the National Board of Boiler and Pressure Vessel Inspectors.

Chapter and Title

I   Glossary of Terms

II   Inspection of Boilers and Pressure Vessels

III   Repairs and Alterations to Boiler and Pressure Vessels by Welding

IV   Shop Inspection of Boilers and Pressure Vessels

V   Inservice Inspection of Pressure Vessels by Authorized Owner-User Inspection Agencies

Appendix and Title

A   Safety and Safety Relief Valves

B   Non-ASME Code Boilers and Pressure Vessels

C   Storage of Mild Steel Covered Arc Welding Electrodes

D-R   National Board “R” (Repair) Symbol Stamp

D-VR   National Board “VR” (Repair of Safety and Safety Relief Valve) Symbol Stamp

D-VR1   Certificate of Authorization for Repair Symbol Stamp for Safety and Safety Relief Valves

D-VR2   Outline of Basic Elements of Written Quality Control System for Repairers of ASME Safety and Safety Relief Valves

D-VR3   Nameplate Stamping for “VR”

E   Owner-user Inspection Agencies

F   Inspection Forms

(c) Records of inspections and repairs shall be kept in accordance with the requirements of the ASME Boiler and Pressure Vessel Code and the National Board Inspection Code. The records shall be made available to the Secretary or his authorized representative.

(d) Sections of the ASME Boiler and Pressure Vessel Code, 1977, listed in paragraph (b)(1) of this section, and chapters and appendices of the National Board Inspection Code, 1979, listed in paragraph (b)(2) of this section, are incorporated by reference and made a part of this standard. These publications may be obtained from the publishers, the American Society of Mechanical Engineers, 22 Law Drive, P.O. Box 2900, Fairfield, New Jersey 07007, Phone: 800-843-2763 (toll free); http://www.asme.org, and the National Board of Boiler and Pressure Vessel Inspectors, 1055 Crupper Avenue, Columbus, Ohio 43229. The publications may be examined at any Metal and Nonmetal Mine Safety and Health District Office of the Mine Safety and Health Administration.

[50 FR 4054, Jan. 29, 1985, as amended at 71 FR 16667, Apr. 3, 2006]


Tried the LawStack mobile app?

Join thousands and try LawStack mobile for FREE today.

  • Carry the law offline, wherever you go.
  • Download CFR, USC, rules, and state law to your mobile device.