40 CFR Table 4
Initial Compliance With Emission Limits
June 9, 2020
As stated in §63.8806, you must comply with the requirements to demonstrate initial compliance with the applicable emission limits in the following table:
Open Table
For . . . | For the following emission limit . . . | You have demonstrated initial compliance if . . . |
---|---|---|
1. Each new, reconstructed, or existing loop slitter adhesive use affected source | Eliminate use of HAP-based adhesives | You do not use HAP-based adhesives. |
2. Each new or reconstructed flame lamination affected source using a scrubber | Reduce HAP emissions by 90 percent | The average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent. |
3. Each new or reconstructed flame lamination affected source using any other control device emissions by | Reduce HAP emissions by 90 percent | The average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent. |