40 CFR § 435.43
Effluent limitations guidelines representing the degree of effluent reduction attainable by the application of the best available technology economically achievable (BAT)
June 9, 2020
CFR

Except as provided in 40 CFR 125.30-125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable (BAT):

BAT Effluent Limitations

Open Table
Stream Pollutant parameter BAT effluent limitations
Produced Water:
(A) All coastal areas except Cook Inlet No discharge.
(B) Cook Inlet Oil & Grease The maximum for any one day shall not exceed 42 mg/l, and the 30-day average shall not exceed 29 mg/l.
Drilling Fluids, Drill Cuttings, and Dewatering Effluent:1
(A) All coastal areas except Cook Inlet No discharge.
(B) Cook Inlet:
Water-based drilling fluids, drill cuttings, and dewatering effluent SPP Toxicity Minimum 96-hour LC50. of the SPP Toxicity Test4 shall be 3% by volume.
    Free oil No discharge.2
    Diesel oil No discharge.
    Mercury 1 mg/kg dry weight maximum in the stock barite.
    Cadmium 3 mg/kg dry weight maximum in the stock barite.
Non-aqueous drilling fluids and dewatering effluent     No discharge.
Drill cuttings associated with non-aqueous drilling fluids     No discharge.5
Well Treatment, Workover and Completion Fluids:
(A) All coastal areas except Cook Inlet No discharge.
(B) Cook Inlet Oil & Grease The maximum for any one day shall not exceed 42 mg/l, and the 30-day average shall not exceed 29 mg/l.
Produced Sand No discharge.
Deck Drainage Free Oil3 No discharge.
Domestic Waste Foam No discharge.

1BAT limitations for dewatering effluent are applicable prospectively, BAT limitations in this rule are not applicable to discharges of dewatering effluent from reserve pits which as of the effective date of this rule no longer receive drilling fluids and drill cuttings. Limitations on such discharges shall be determined by the NPDES permit issuing authority.

2As determined by the static sheen test. See §435.41(ff).

3As determined by the presence of a film or sheen upon or a discoloration of the surface of the receiving water (visual sheen).

4As determined by the suspended particulate phase (SPP) toxicity test. See §435.41(ee).

5When Cook Inlet operators cannot comply with this no discharge requirement due to technical limitations (see appendix 1 of subpart D of this part), Cook Inlet operators shall meet the same stock limitations (C16-C18 internal olefin) and discharge limitations for drill cuttings associated with non-aqueous drilling fluids for operators in Offshore waters (see §435.13) in order to discharge drill cuttings associated with non-aqueous drilling fluids.

[61 FR 66125, Dec. 16, 1996; 62 FR 1681, Jan. 13, 1997, as amended at 66 FR 6917, Jan. 22, 2001; 77 FR 29846, May 18, 2012]


Tried the LawStack mobile app?

Join thousands and try LawStack mobile for FREE today.

  • Carry the law offline, wherever you go.
  • Download CFR, USC, rules, and state law to your mobile device.