amended at 72 FR 58259, Oct. 15, 2007; 77 FR 15975, Mar. 19, 2012; 80 FR 10395, Feb. 26, 2015; 80 FR 46520, Aug. 5, 2015; 85 FR 7250, Feb. 7, 2020]

law enforcement inquiry and will further that inquiry; (c) The request is issued by a supervisory official of a grade designated by the head of the DoD Component. Officials so designated shall not delegate this authority to others; (d) The request adheres to the requirements set forth in § 275.4; and (e) The notice requirements required by section 1108

G. Civil Justice Reform (E.O. 12988) This rule complies with the requirements of E.O. 12988. Specifically, this rule: (1) Meets the criteria of section 3(a) requiring that all regulations be reviewed to eliminate errors and ambiguity and be written to minimize litigation; and (2) Meets the criteria of section 3(b)(2) requiring that all regulations be

Pm = measured pressure in mm Hg (absolute), and Tm = measured temperature in degrees Celsius. 4.4.3 Select the operating range of the CO analyzer to be calibrated. Connect the

) Release Point Apportionment Percent. (23) Release Point Type. (24) Control Measure and Control Pollutant (where applicable). (25) Percent Control Approach Capture Efficiency (where applicable). (26) Percent Control Measures Reduction Efficiency (where

§§51.121 and 51.122, including the statewide NOX emission budgets, continue to be met and the State makes a showing consistent with section 110(l) of the CAA. [69 FR 23996, Apr. 30, 2004, as amended at 70 FR 30604, May 26, 2005; 70 FR 44474, Aug. 3, 2005; 77 FR 28441, May 14, 2012]

Pb means lead. PM means PM10, PM10C, PM2.5, PM10-2.5, or particulate matter of unspecified size range. PM

Petroleum refinery means any facility engaged in producing gasoline, kerosene, distillate fuel oils, residual fuel oils, lubricants, asphalt (bitumen) or other products through distillation of petroleum or through redistillation, cracking or reforming of unfinished petroleum derivatives. A facility that produces only oil shale or tar sands-derived crude oil for further processing at a petroleum refinery using only solvent extraction and/or distillation

Americans for food preparation, cooking, warming or for instructional, recreational, cultural or ceremonial purposes. Unseasoned wood means wood with an average moisture content of 20 percent or more. Valid certification test means a test that meets the following criteria: (1) The Administrator was notified about the

)(2) of this section; or (2) The owner or operator meets the conditions for control system removal specified in paragraph (b)(2)(v) of this section. [81 FR 59368, Aug. 29, 2016, as amended at 85 FR 17261, Mar. 26, 2020]

Process unit turnaround means the shutting down of the operations of a process unit, the purging of the contents of the process unit, the maintenance or repair work, followed by restarting of the process. Process unit turnaround waste means a waste that is generated as a result of a process unit turnaround.

[59 FR 19468, Apr. 22, 1994, as amended at 60 FR 63628, Dec. 12, 1995; 62 FR 2775, Jan. 17, 1997; 64 FR 20192, Apr. 26, 1999]

such as gasoline or crude oil in bulk. Nonvapor-tight means any marine tank vessel that does not pass the required vapor-tightness test. Offshore loading terminal means a location that has at least one loading berth that is 0.81 km (0.5 miles) or more from the shore that is used for mooring a marine tank vessel and loading liquids from shore.

a temperature of at least 426 °C (800 °F). Inorganic zinc (high-build) specialty coating means a coating that contains 960 grams per liter (8 pounds per gallon) or more elemental zinc incorporated into an inorganic silicate binder that is applied to steel to provide galvanic corrosion resistance. (These coatings are typically applied at more than 2 mil dry film thickness.)

including dripping, spraying, misting, clouding, and ice formation. Indications of liquids dripping include puddling or new stains that are indicative of an existing evaporated drip. Nonrepairable means that it is technically infeasible to repair a piece of equipment from which a leak has been detected without a process unit or affected facility shutdown. Open-ended

, as propane. (9) Method 26A for the concentration of HCl and HF. Method 26 may also be used, except at sources where entrained water droplets are present in the emission stream. Where a lime-injected fabric filter is used as the control device to comply with the 90 percent reduction standard, the owner or operator must measure the fabric filter inlet concentration of HCl at a point before lime is introduced to the system. (d)

monitor; or continuous opacity monitoring system, your performance evaluation shows the system meets the applicable requirements in §63.1572. [80 FR 75290, Dec. 1, 2015, as amended at 81 FR 45244, July 13, 2016; 83 FR 60726, Nov. 26, 2018]

d. Measure moisture content of the stack gas Method 4 (40 CFR part 60, appendix A)     e. Measure the HCl concentration at the selected sampling locations Method 26 or 26A (40 CFR part 60, appendix A). If your control device is a wet scrubber

component located inside the perimeter of the landfill waste. A perimeter well located outside the landfilled waste is not an interior well. Landfill means an area of land or an excavation in which wastes are placed for permanent disposal, and that is not a land application unit, surface impoundment, injection well, or waste pile as those terms are defined under

Mass fraction of organic HAP means the ratio of the mass of organic HAP to the mass of a material in which it is contained, expressed as kg of organic HAP per kg of material. Month means a calendar month or a pre-specified period of 28 days to 35 days to allow for flexibility in recordkeeping when data are based on a business accounting period.

Missouri. Missouri Department of Natural Resources, Division of Environmental Quality, P.O. Box 176, Jefferson City, Missouri 65102. (26) Montana. Department of Health and Environmental Services, Air Quality Bureau, Cogswell Building, Helena, Montana 59601. (27) Nebraska. Nebraska Department of Environmental Control, P.O. Box

1102.9   Prompt Reporting of Deviations 1104.1   Definitions (a) Administrative Permit Amendment (b) AP-42 (c) Applicable requirement (d) Federal oversight source (e) Insignificant source (f) Insignificant sources—Type I

this part. (g) Minimum recording and recordkeeping requirements. The owner or operator shall record and the designated representative shall report the hourly, daily, quarterly, and annual information collected under the requirements of this part as specified in subparts F and G of this part. [58 FR 3701, Jan. 11, 1993, as amended at 60 FR 26519, May 17, 1995; 64 FR 28590, May 26

§75.58(b)(3) and the related QA/QC program information to the Administrator, to the EPA Regional Office, or to the appropriate State or local agency, upon request. [60 FR 26567, May 17, 1995, as amended at 61 FR 59160, Nov. 20, 1996; 64 FR 28604, May 26, 1999; 67 FR 40438, June 12, 2002; 73 FR 4348, Jan. 24, 2008; 76 FR 17312, Mar. 28, 2011]

, Nov. 22, 1996; 64 FR 28620, May 26, 1999; 67 FR 40442, 40443, June 12, 2002; 73 FR 4356, Jan. 24, 2008; 76 FR 17316, Mar. 28, 2011]

, 2006; 75 FR 75078, Dec. 1, 2010; 76 FR 48379, Aug. 8, 2011; 81 FR 74603, Oct. 26, 2016]

date the petition was filed by the Division of Dockets Management; (3) The name of the petitioner; (4) The subject matter involved; and (5) The disposition of the petition. [44 FR 22323, Apr. 13, 1979, as amended at 46 FR 8455, Jan. 27, 1981; 50 FR 16656, Apr. 26, 1985; 54 FR 9034, Mar. 3, 1989; 57 FR 17980, Apr. 28, 1992; 59 FR 14364, Mar. 28, 1994; 62

, quality, and fitness for consumption of all tea imported into the United States under 21 U.S.C. 42. (2) Science Board to the Food and Drug Administration. (i) Date established: June 26, 1992. (ii) Function: The board shall provide advice primarily to the agency's

name of the product, the lot number, and the filling identification. [38 FR 32048, Nov. 20, 1973, as amended at 41 FR 10428, Mar. 11, 1976; 49 FR 23833, June 8, 1984; 55 FR 11013, Mar. 26, 1990; 68 FR 75119, Dec. 30, 2003; 70 FR 14982, Mar. 24, 2005; 72 FR 59003, Oct. 18, 2007; 80 FR 18092, Apr. 3, 2015]

FIPS 180-2, as incorporated by reference in §1311.08 of this chapter, means the National Institute of Standards and Technology publication entitled “Secure Hash Standard,” a Federal secure hash standard. FIPS 180-3, as incorporated by reference in