approved for 13 persons or more must carry two of these items. 2Not required for boats of self-bailing design. 3Not required for inflated or rigid-inflated rescue boats. 4Oars not required on a free-fall lifeboat; a unit of oars means the number of oars specified by the boat manufacturer.

disposition of natural resource recapture property, see paragraphs (b)(3), (c), and (d) of this section. For exceptions and limitations to the application of section 1254(a), see §1.1254-2. (b) Definitions—(1) Section 1254 costs—(i) Property placed in service

, at least one floor-level exit must be located in each side near each end of the cabin. (4) For an airplane that is required to have more than one passenger emergency exit for each side of the fuselage, no passenger emergency exit shall be more than 60 feet from any adjacent passenger emergency exit on the same side of the same deck of the fuselage, as measured parallel to the airplane's longitudinal axis between the nearest exit edges.

occur on or after November 6, 2006. For guidance with respect to §1.367(b)-1(c)(3)(ii)(A), (c)(4)(iv), and (c)(4)(v) and §1.367(b)-2(j)(1)(i) for exchanges that occur before November 6, 2006, see 26 CFR part 1 revised as of April 1, 2006. (iv)

the logs: (i) are transported in a crib-type log trailer (as defined in 49 CFR 393.5), and (ii) are loaded in compliance with paragraphs (b)(2) and (c) of this section. (4) The aggregate working load limit for tiedowns used to secure a stack of logs on a frame vehicle, or a flatbed vehicle equipped with bunks, bolsters, or stakes must be at least one-sixth the weight of the stack of logs.

inactivation, removal, or a State-approved combination of 4-log virus inactivation and removal) before or at the first customer for any ground water source(s). (d) The reports submitted pursuant to this section shall be made available by the State to the public for inspection at one or more locations within the State. [41 FR 2918, Jan. 20, 1976]

§1.6015-4 is available only to a requesting spouse who fails to qualify for relief under §§1.6015-2 and 1.6015-3. If a requesting spouse elects the application of either §1.6015-2 or 1.6015-3, the Internal Revenue Service will consider whether

section 30116 of Title 52, Voting and Elections. Amendments 2014—Subsec. (a). Pub. L. 113–295 substituted "section 315(b)(1)(A)" for "

The following industrial subcategories are considered to have dilute wastestreams for purposes of the combined wastestream formula. They either were or could have been excluded from categorical pretreatment standards pursuant to paragraph 8 of the Natural Resources Defense Council, Inc., et al. v. Costle Consent Decree for one or more of the following four reasons: (1) The pollutants of concern are not detectable in the effluent from the industrial user (paragraph 8

For purposes of the taxes imposed by this subtitle upon a DISC (as defined in section 992(a)), a DISC shall not be subject to the taxes imposed by this subtitle. Editorial Notes

undetected attitude and heading errors, possibly resulting in loss of control of the aircraft. The NPRM also advised that the proposed AD would affect AD 2010-26-09 (75 FR 81424, December 28, 2010) (“AD 2010-26-09”), which applies to Sikorsky Model S-76A, B, and C helicopters with an AHRS unit P/N 145130-7100 installed. Since the NPRM proposed to require the removal of P/N 145130-7100, compliance with the proposed would make AD 2010-26-09 no longer valid for

; (2) Sums offered for purchase of real estateSums offered for the purchase of real estate under the provisions of section 7506; (3) Surplus proceeds in sales under levySurplus proceeds in any sale under levy, after making allowance for the amount of the tax, interest, penalties, and additions

a digital audio recording device or digital audio recording medium who has not previously filed notice of the importation or manufacture for distribution of such device or medium in the United States. (2) The product category of a device or medium is a general class of products made up of functionally equivalent digital audio recording devices or media with substantially the same use in substantially the same environment

psi), but the standard temperature for determining the volume corresponding to one mole is 20 °C (68 °F). K = conversion constant, 1.740 × 107 (g-mole) (MJ)/(ppm-scm-kcal) (metric units); or 4.674 × 108 ((g-mole) (Btu)/(ppm-scf-kcal)) (English units) Ci = Concentration of sample component “i” in ppm, as measured by Method 18 of appendix A to 40 CFR part 60 and ASTM D2504-67, 77, or 88 (Reapproved 1993

The electors shall make and sign six certificates of all the votes given by them, each of which certificates shall contain two distinct lists, one of the votes for President and the other of the votes for Vice President, and shall annex to each of the certificates of votes one of the certificates of ascertainment of appointment of electors which shall have been furnished to them by direction of the executive of the State.

A separate report of the issuance or renewal of a policy and endorsement, provided for by §726.208, shall be made for each operator covered by a policy. If a policy is issued or renewed insuring more than one operator, a separate report for each operator so covered shall be sent to the Office with the name of only one operator on each such report.

this title. Provisions of the act establishing the revolving fund are set out in section 5113 of this title. For complete classification of this Act to the Code, see Short Title note set out under section 5101 of this title and Tables. Act of June 26, 1936

) Cross references (1) For rules relating to recognition of gain or loss where an exchange is not solely in kind, see subsections (b) and (c) of section 1031. (2) For rules relating to the basis of property acquired in an exchange described in subsection (a), see subsection (d) of

(a) In general. A corporation, trust, or association which fails to meet the requirements of paragraph (2) or (3) of section 856(c), or of both such paragraphs, for any taxable year nevertheless is considered to have satisfied these requirements if the corporation, trust, or association meets the requirements of subparagraphs (A), (B), and (C) of section 856(c)(7) (relating to a schedule attached to the return, the absence of

section 6621" for "an annual rate established under section 6621". 1975—Pub. L. 93–625 substituted "an annual rate established under section 6621" for "the rate of 6 percent per annum".

(2) If the settlement agreement approved by the Regional Director is a formal one, providing for the entry of a Board order, the settlement agreement together with the charging party's objections and the Regional Director's written statements are submitted to Washington, DC, where they are reviewed by the General Counsel. If the General Counsel decides to approve the settlement agreement, the charging party is so informed and the agreement and accompanying documents are submitted to the Board

deductions and credits; subsec. (g), foreign tax credit; subsec. (h), provisions relating to employees of United States. 1984—Subsec. (d)(2)(B). Pub. L. 98–369 substituted "for losses" for ", for losses of property not connected with the trade or business if arising from certain casualties or theft,". 1977—Subsec. (d)(3). Pub. L. 95–30 struck out par. (3) which made a cross reference to

site employee, and (2) the exemptions, exclusions, definitions, and other rules which are based on type of employer and which would (but for paragraph (1)) apply shall apply with respect to such taxes imposed on such remuneration. (b) Successor employer statusFor purposes of sections 3121(a)(1), 3231(e)(2)(C), and 3306

1 insured or held by the Secretary under section 1715z–22 of this title, but not reinsured under section 1715z–22 of this title; or (D) any applicable regulation. For purposes of this section, a use of assets or income in violation of the regulatory agreement, or such other form of

(ii) Inside surfaces must be clean, dry, and free of loose particles. (iii) No defect of any kind is permitted if it is likely to weaken a finished cylinder. (2) Requirements for seams: (i) Brazing is not authorized on aluminum cylinders. (ii) Brazing material must have a melting point of not lower than 1,000 °F.