The procedures described in this and subsequent sections will be the test program to determine the conformity of vehicles with the standards set forth in §205.52 for the purposes of Selective Enforcement Auditing and Testing by the Administrator. [47 FR 57714, Dec. 28, 1982]

In consultation with the responsible agencies, the owner/operator shall determine what wastes shall be accepted and shall identify any special handling required. In general, only wastes for which the facility has been specifically designed shall be accepted; however, other wastes may be accepted if it has been demonstrated to the responsible agency that they can be satisfactorily processed within the design capability of the facility or after appropriate facility modifications.

(a) Whenever possible, thermal processing facilities should be located in areas zoned for industrial use and having adequate utilities to serve the facility. (b) The site should be accessible by permanent roads leading from the public road system. (c) Environmental factors, climatological conditions, and socioeconomic factors should be given full consideration as selection criteria.

If you are a facility owner or operator who has fully complied with the requirements for interim status—as defined in section 3005(e) of RCRA and regulations under 40 CFR 270.70—you must comply with the regulations specified in 40 CFR part 265 instead of the regulations in this part, until final administrative disposition of the standardized permit application is made, except as provided under 40 CFR part 264, subpart S.

You are required to keep records of: (a) All data used to complete RAP applications and any supplemental information that you submit for a period of at least 3 years from the date the application is signed; and (b) Any operating and/or other records the Director requires you to maintain as a condition of your RAP.

For the purpose of this subpart: (a) Except as provided below, the general definitions, abbreviations and methods of analysis set forth in 40 CFR part 401 shall apply to this subpart. (b) The term gross cane shall mean that amount of crop material as harvested, including field trash and other extraneous material.

For the purpose of this subpart: (a) Except as provided below, the general definitions, abbreviations and methods of analysis set forth in 40 CFR part 401 shall apply to this subpart. (b) The term gross cane shall mean that amount of crop material as harvested, including field trash and other extraneous material.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.172.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.232.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.422.

Except as provided in 40 CFR 125.30 through 125.32 any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.652.

Except as provided in 40 CFR 125.30 through 125.32 any existing point source subject to this subpart must achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.662.

Except as provided in 40 CFR 125.30 through 125.32 any existing point source subject to this subpart must acheive the following effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology (BCT): The limitations are the same for TSS and pH as specified in §415.672.

Compliance with the pretreatment standards for existing sources set forth in §420.45(d) of this subpart is required not later than October 17, 2005 whether or not the pretreatment authority issues or amends a pretreatment permit requiring such compliance. [67 FR 64268, Oct. 17, 2002]

For the purpose of this subpart: (a) Except as provided below, the general definitions, abbreviations and methods of analysis set forth in 40 CFR part 401 shall apply to this subpart. (b) The term Mwh shall mean megawatt hour(s) of electrical energy consumed in the smelting process (furnace power consumption).

For the purpose of this subpart: (a) Except as provided below, the general definitions, abbreviations and methods of analysis set forth in part 401 of this chapter shall apply to this subpart. (b) The term Mwh shall mean megawatt hour(s) of electrical energy consumed in the smelting process (furnace power consumption).

This subpart applies to discharges to waters of the United States and to the introduction of process wastewater pollutants into publicly owned treatment works from the manufacture of wood furniture and fixtures at establishments that (a) do not utilize water wash spray booths to collect and contain the overspray from spray applications of finishing materials and (b) do not maintain on-site laundry facilities for fabric utilized in various finishing operations.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart that slaughters more than 50 million pounds per year (in units of LWK) must achieve the following effluent limitations representing the application of BAT: Limitations for ammonia (as N) and total nitrogen are the same as specified in §432.13.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart that slaughters more than 50 million pounds per year (in units of LWK) must achieve the following effluent limitations representing the application of BAT: the limitations for ammonia (as N) and total nitrogen are the same as specified in §432.13.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart that slaughters more than 50 million pounds per year (in units of LWK) must achieve the following effluent limitations representing the application of BAT: Limitations for ammonia (as N) and total nitrogen are the same as specified in §432.13.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the application of BCT: Limitations for BOD5, TSS, oil and grease (HEM) and pH are the same as the corresponding limitation specified in §442.11.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the application of BCT: Limitations for BOD5, TSS, oil and grease (HEM) and pH are the same as the corresponding limitation specified in §442.21.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the application of BCT: Limitations for BOD5, TSS, oil and grease (HEM) and pH are the same as the corresponding limitation specified in §442.31.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations representing the application of BCT: Limitations for BOD5, TSS, oil & grease (HEM) and pH are the same as the corresponding limitation specified in §442.41.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations which represent the application of BCT: Limitations for BOD5, TSS and pH are the same as the corresponding limitations specified in §445.11.

Except as provided in 40 CFR 125.30 through 125.32, any existing point source subject to this subpart must achieve the following effluent limitations which represent the application of BCT: Limitations for BOD5, TSS and pH are the same as the corresponding limitations specified in §445.21.

Each person who is subject to the reporting requirements of this part must retain records that document any information reported to EPA. Records relevant to a reporting year must be retained for a period of 3 years beginning on the last day of the reporting year. Submitters are encouraged to retain their records longer than 3 years to ensure that past records are available as a reference when new submissions are being generated.

The Secretary of Labor, with respect to any matter under this part, may— (1) issue subpoenas for and compel the attendance of witnesses; (2) administer oaths; (3) examine witnesses; and (4) require the production of books, papers, documents, and other evidence.

The primary purpose of this subchapter is to assist the efforts of States, local governments, neighborhood and other organizations to provide a more suitable living environment, expand cultural opportunities, and to the extent practicable, stimulate economic opportunities, primarily for the low and moderate income residents of communities and neighborhoods in need of conservation and revitalization, through the utilization, design or development of artistic, cultural, or

For purposes of this subpart the terms individual, maintain, record, system of records, statistical record, and routine use shall have the meanings set forth in 5 U.S.C. 552a(a). The term agency shall mean an agency of USDA, unless otherwise indicated.