requirement under section 113 (a), (b), or (c) of the Act; (2) Revoke the order after notice and opportunity for hearing; (3) Give notice of noncompliance and commence action under section 120 of the act; or (4) Take any appropriate combinations of these actions. (c) Under section 304 of the Act, any person may commence a civil action against an owner or operator of a

with the emission limitation. Each NSO shall require the use of specific, enforceable testing methods and measurement periods for determining compliance with the limitation established under paragraph (a) of this section.

(a) The owner or operator of an affected facility for which construction is commenced after September 15, 1997 shall prepare an analysis of the impacts of the affected facility. The analysis shall consider air pollution control alternatives that minimize, on a site-specific basis, to the maximum extent practicable, potential risks to public health or the environment. In considering such alternatives, the analysis may consider costs, energy impacts, non-air

(a) The affected facility to which the provisions of this subpart apply is the total of all the loading racks at a bulk gasoline terminal which deliver liquid product into gasoline tank trucks. (b) Each facility under paragraph (a) of this section, the construction or modification of which is commenced after December 17, 1980, is subject to the provisions of this subpart. (c) For purposes of this subpart

manufacturers in research and development of equipment for both combustion turbine emission control techniques and combustion turbine efficiency improvements are exempt from the NOX emission limits in §60.4320 on a case-by-case basis as determined by the Administrator. (c) Stationary combustion turbines at integrated

(a) Identification of Plan. Massachusetts Plan for the Control of Designated Pollutants from Existing Plants (Section 111(d) Plan). (b) The plan was officially submitted as follows: (1) Control of metals, acid gases, organic compounds and nitrogen oxide emissions from existing municipal waste combustors, originally submitted on January 11, 1999 and amended on

: (1) PVS Chemicals, Inc., Buffalo. (2) Eastman Kodak Company, Rochester. (d) The plan is approved with the provision that for existing sources any variance or compliance date extension from the provisions of part 224, “Sulfuric Acid and Nitric Acid Plants,” or any text method other than specified in 40 CFR part 60, appendix A, approved by the Commissioner of Environmental Conservation must be

equivalence referred to in paragraph (a) of this section will be based on the application to the Administrator which shall include the information specified in either paragraph (b)(1) or (b)(2) of this section. (1) Actual emissions tests that use full-size or scale-model storage vessels that accurately collect and measure all organic HAP emissions from a given control technique, and that accurately simulate wind and account for other emission variables such as

(a) The owner or operator of a primary lead processor must comply with the notification requirements of §63.9 of subpart A, General Provisions as specified in Table 1 of this subpart. (b) The owner or operator of a primary lead processor must submit the standard operating procedures manual for baghouses required under

(a) You must monitor and collect data according to subpart SS of this part and paragraphs (b) and (c) of this section. (b) When using a control device to comply with this subpart, you must monitor continuously or collect data at all required intervals at all times that the emission source and control device are in OLD operation, except for CMS malfunctions (including any malfunction preventing the CMS from operating properly

You must complete the initial compliance demonstration for the initial compliance period according to the requirements in §63.3521. The initial compliance period begins on the applicable compliance date specified in §63.3483 and ends on the last day of the 12th month following the compliance

You must complete the initial compliance demonstration for the initial compliance period according to the requirements in §63.4141. The initial compliance period begins on the applicable compliance date specified in §63.4083 and ends on the last day of the first full month after the compliance

You must complete the compliance demonstration for the initial compliance period according to the requirements in §63.4321. The initial compliance period begins on the applicable compliance date specified in §63.4283 and ends on the last day of the first full month after the compliance date. The

You must complete the initial compliance demonstration for the initial compliance period according to the requirements in §63.4741. The initial compliance period begins on the applicable compliance date specified in §63.4683 and ends on the last day of the 12th month following the compliance

requirements in §63.8252. Several of these notifications must be submitted before the compliance date for your affected source(s).

Each owner or operator of an affected source under this subpart must comply with the requirements of paragraphs (a) and (b) of this section. (a) You must, at all times, operate and maintain any affected source, including associated air pollution control equipment and monitoring equipment, in a manner consistent with safety and good air pollution control practices for minimizing emissions. Determination of whether such operation and

Each owner or operator of an affected source under this subpart must comply with the requirements of paragraphs (a) and (b) of this section. (a) You must, at all times, operate and maintain any affected source, including associated air pollution control equipment and monitoring equipment, in a manner consistent with safety and good air pollution control practices for minimizing emissions. Determination of whether such operation and

listed on that website; or a paper submission to the EPA's designated physical address listed on that website. Any necessary attachments must be submitted together with the petition, using the same method as for the petition. Once a petition has been successfully submitted using one of these three methods, the petitioner should not submit additional copies of the petition using another method. The Administrator is not obligated to consider petitions submitted to the agency using any method other than

§80.75(m). (b) Record retention. The CPA or CIA shall retain all records pertaining to the performance of each agreed upon procedure and pertaining to the creation of the agreed upon procedures report for a period of five years from the date of creation and shall deliver such records to the Administrator upon request.

) A statement that the article of food must not be consumed, moved, altered, or tampered with in any manner for the period shown, without the written permission of an authorized FDA representative; (c) A statement that the violation of a detention order or the removal or alteration of the tag or label is a prohibited act, punishable by fine or imprisonment or both; and (d) The detention order number, the date and hour of the detention

(a) Promptly after the taking of evidence is completed, the presiding officer will announce a schedule for the filing of briefs. Briefs are to be filed ordinarily within 45 days of the close of the hearing. Briefs must include a statement of position on each issue, with specific and complete citations to the evidence and points of law relied on. Briefs must contain proposed findings of fact and conclusions of law. (b) The presiding

(a) The presiding officer shall conduct a hearing on the record to determine whether the respondent is liable for a civil money penalty and, if so, the appropriate amount of any such civil money penalty considering any aggravating or mitigating factors. (b) In order to prevail, the Center must prove respondent's liability and the appropriateness of the penalty under the applicable statute by a preponderance of the evidence.

Where the Food and Drug Administration consults with a person who will be affected by a proposed disclosure of data or information contained in Food and Drug Administration records pursuant to §20.47, and rejects the person's request that part or all of the records not be made available for public disclosure, the decision constitutes final agency action that is subject

having additive toxic effects. (c) Pesticide chemicals may also cause pharmacological or biological effects similar or related to such effects caused by color additives, and, in the absence of evidence to the contrary, those that do so will be considered to have additive toxic effects. (d) In establishing tolerances for color additives, the Commissioner will take into consideration, among other things, the amount of any common component

(a) Identity and specifications. The color additive FD&C Green No. 3 shall conform in identity and specifications to the requirements of §74.203(a)(1) and (b). (b) Uses and restrictions. The color additive FD&C Green No. 3 may be safely used for coloring

(a) Identity and specifications. The color additive D&C Green No. 6 shall conform in identity and specifications to the requirements of §74.1206 (a) and (b). (b) Uses and restrictions. D&C Green No. 6 may be safely used for coloring externally applied

(a) Identity and specifications. The color additive D&C Orange No. 4 shall conform in identity and specifications to the requirements of §74.1254 (a)(1) and (b). (b) Uses and restrictions. D&C Orange No. 4 may be safely used for coloring externally

(a) Identity and specifications. The color additive D&C Orange No. 10 shall conform in identity and specifications to the requirements of §74.1260(a)(1) and (b). (b) Uses and restrictions. D&C Orange No. 10 may be safely used for coloring externally

(a) Identity and specifications. The color additive D&C Orange No. 11 shall conform in identity and specifications to the requirements of §74.1261(a)(1) and (b). (b) Uses and restrictions. D&C Orange No. 11 may be safely used for coloring externally

(a) Identity and specifications. The color additive D&C Red No. 6 shall conform in identity and specifications to the requirements of §74.1306 (a)(1) and (b). (b) Uses and restrictions. The color additive D&C Red No. 6 may be safely used for coloring