that the proposed method for placing woody material within the backfill will not deteriorate the stable condition of the backfilled area. [48 FR 23370, May 24, 1983, as amended at 48 FR 41735, Sept. 16, 1983; 81 FR 93418, Dec. 20, 2016; 82 FR 54999, Nov. 17, 2017]

This section explains the procedures ONRR will use to terminate all or a part of your delegation agreement: (a) ONRR will notify you in writing that it is initiating procedures to terminate your delegation agreement; (b) ONRR will provide you notice and opportunity for a hearing under §1227.803 of this

. 136l(a)). Where inconsistencies exist between this section and §§22.1 through 22.32, this section shall apply. (b) Venue. The prehearing conference and the hearing shall be held in the county, parish, or incorporated city of the residence of the person charged, unless otherwise agreed in writing by all parties. For a person whose

reviewing official. (c) Except as provided in paragraph (a) of this section, the representative for the Government may be employed anywhere in the authority, including in the offices of either the investigating official or the reviewing official. [53 FR 15182, Apr. 27, 1988, as amended at 57 FR 5326, Feb. 13, 1992]

(ii) Protection of national resources by conservation. (b) Pollution prevention/source reduction does not include any practice which alters the physical, chemical, or biological characteristics or the volume of a hazardous substance, pollutant, or contaminant through a process or activity which itself is not integral to and necessary for the production of a product or the providing of a service.

(a) Application requirements. The applicant must comply with the requirements described in §35.6105(a)(1) and (3), and other requirements as negotiated with EPA. (Indian Tribes are exempt from the requirement of Intergovernmental Review in 40 CFR part 29.) An applicant may submit a non-site-specific budget for support agency

Sections 301(d)(2) and 302(r), 42 U.S.C. 7601(d)(2) and 7602(r), authorize the Administrator to treat an Indian tribe in the same manner as a State for the Clean Air Act provisions identified in §49.3 if the Indian tribe meets the following criteria:

(a) [Reserved] (b) The compliance schedules for the sources identified below are disapproved as not meeting the requirements of Subpart N of this chapter. The regulations cited are air pollution control regulations of the State. Open Table

Unless otherwise ordered by the Presiding Officer, each hearing participant may, within 20 days after reply comments are submitted under §57.805(b), or if a supplementary hearing for the purpose of cross-examination has been held under §57.808(c), within 20 days after the transcript of such

This section identifies the consumer and commercial product categories for which EPA has determined that CTGs will be substantially as effective as regulations in reducing VOC emissions in ozone nonattainment areas: (a) Wood furniture coatings; (b) Aerospace coatings; (c) Shipbuilding and repair coatings; (d) Lithographic printing materials

(b) The owner or operator shall determine compliance with the particulate matter standards in §60.122 as follows: (1) Method 5 shall be used to determine the particulate matter concentration during representative periods of furnace operation, including charging and tapping. The sampling time and sample volume for each run shall be at least 60 minutes

(a) The affected facility to which the provisions of this subpart apply is each calciner and dryer at a mineral processing plant. Feed and product conveyors are not considered part of the affected facility. For the brick and related clay products industry, only the calcining and drying of raw materials prior to firing of the brick are covered. (b) An affected facility that is subject to the provisions of subpart LL, Metallic Mineral

If your municipal waste combustion unit uses activated carbon to control dioxins/furans or mercury emissions, you must meet three requirements: (a) Select a carbon injection system operating parameter that can be used to calculate carbon feed rate (for example, screw feeder speed). (b) During each dioxins/furans and mercury stack test, determine the average carbon feed rate in kilograms (or pounds

If your municipal waste combustion unit uses activated carbon to control dioxins/furans or mercury emissions, you must meet three requirements: (a) Select a carbon injection system operating parameter that can be used to calculate carbon feed rate (for example, screw feeder speed). (b) During each dioxins/furans and mercury stack test, determine the average carbon feed rate in kilograms (or pounds

unit makes physical or operational changes to a SSI unit for which construction commenced on or before September 21, 2011 primarily to comply with your state plan, subpart LLLL of this part does not apply to that unit. Such changes do not qualify as modifications under subpart LLLL of this part.

Vermont 08/20/96 aA MSW landfill with a design capacity equal to or greater than 2.5 million megagrams and 2.5 million cubic meters located in an area for which a negative declaration letter was submitted is subject to the Federal plan, notwithstanding the negative declaration letter and this table 2.

of Mechanical Engineers on or before the effective date of this subpart. (d) You may request that the EPA Administrator waive the requirement in paragraph (a) of this section for chief facility operators, shift supervisors, and control room operators who have obtained provisional certification from the American Society of Mechanical Engineers on or before the effective date of this subpart.

If your municipal waste combustion unit uses activated carbon to control dioxins/furans or mercury emissions, you must meet three requirements: (a) Select a carbon injection system operating parameter that can be used to calculate carbon feed rate (for example, screw feeder speed). (b) During each dioxins/furans and mercury stack test, determine the average carbon feed rate in kilograms (or pounds

product. Table 8 to this subpart contains a summary of compliance alternative requirements for the emission limits in §63.494(a)(1)-(3) and associated requirements. [76 FR 22589, Apr. 21, 2011]

You must complete the initial compliance demonstration for the initial compliance period according to the requirements of §63.3531. The initial compliance period begins on the applicable compliance date specified in §63.3483 and ends on the last day of the 12th month following the compliance

You must complete the initial compliance demonstration for the initial compliance period according to the requirements in §63.3941. The initial compliance period begins on the applicable compliance date specified in §63.3883 and ends on the last day of the 12th month following the compliance

You must complete the initial compliance demonstration for the initial compliance period according to the requirements in §63.4541. The initial compliance period begins on the applicable compliance date specified in §63.4483 and ends on the last day of the 12th month following the compliance

You must complete the initial compliance demonstration for the initial compliance period according to the requirements of §63.4751. The initial compliance period begins on the applicable compliance date specified in §63.4683 and ends on the last day of the 12th month following the compliance

As specified in §63.5758(a)(6), when detailed organic HAP content data for solvent blends are not available, you may use the values in the following table: Open Table

source to minimize emissions in accordance with §63.11115(a), including actions taken to correct a malfunction. No report is necessary for a calendar year in which no malfunctions occurred. [76 FR 4183, Jan. 24, 2011]

operator may submit such information separately. The requirements of section 114(c) shall apply to such information. (2) The contents of a title V permit shall not be entitled to protection under section 114(c) of the Act; however, information submitted as part of an application for a title V permit may be entitled to protection from disclosure.

(a) The owner or operator shall prepare and implement procedures to maintain the on-going mechanical integrity of the process equipment. The owner or operator may use procedures or instructions provided by covered process equipment vendors or procedures in Federal or state regulations or industry codes as the basis for stationary source maintenance procedures. (b) The owner or operator shall train or cause to be trained each employee

similar manner, will cause serious adverse health consequences or death to humans or animals, any records and other information accessible to FDA under section 414 or 704(a) of the Federal Food, Drug, and Cosmetic Act (21 U.S.C. 350c and 374(a)) must be made readily available for inspection and photocopying or other means of reproduction. Such records and other information must be made available as soon as

(a) Part 10 governs practices and procedures for petitions, hearings, and other administrative proceedings and activities conducted by the Food and Drug Administration under the Federal Food, Drug, and Cosmetic Act, the Public Health Service Act, and other laws which the Commissioner of Food and Drugs administers. (b) If a requirement in another part of title 21 differs from a requirement in this part, the requirements of this part

§13.30(i) for filing a written statement of position with proposed findings and conclusions. (c) The Board may, in its discretion, reopen the record to receive further evidence at any time before filing an initial decision.