of the total allowable costs of the proposed treatment works until the grantee has furnished and the Regional Administrator has approved an operation and maintenance manual. (2) In projects where a component is placed in operation before completion of the entire project, the Regional Administrator shall not make any additional payment on that project until a final operation and maintenance manual for the operating component is furnished and approved.

) Fixed in-place equipment. EPA no longer has an interest in fixed in-place equipment once the equipment is installed. (ii) Equipment that is an integral part of services to individuals. EPA no longer has an interest in equipment that is an integral part of services to individuals, such as pipes, lines, or pumps providing hookups for homeowners on an existing water distribution system

federally recognized as eligible for the special programs and services provided by the United States to Indians because of their status as Indians. (d) Indian Tribe Consortium or Tribal Consortium means a group of two or more Indian tribes. (e) State means a State, the District of Columbia, the Commonwealth of Puerto Rico

the provisions of sections 304(a) and 301(d)(4), if a tribe does not submit a tribal implementation plan meeting the completeness criteria of 40 CFR part 51, appendix V, or does not receive EPA approval of a submitted tribal implementation plan. (b) May provide up to 95 percent of the cost of implementing programs for the prevention and control of air pollution or implementation of national primary and secondary ambient air quality standards. After two years from

(a) Initial classification as Moderate PM2.5 nonattainment area. Any area designated nonattainment for a PM2.5 NAAQS shall be classified at the time of such designation, by operation of law, as a Moderate PM2.5 nonattainment area

(a) The Montana plan, as submitted, is approved as meeting the requirements of Part C, Subpart 1 of the Clean Air Act, except that it does not apply to sources proposing to construct on Indian Reservations. (b) Regulation for preventing significant deterioration of air quality. The provisions of §52.21 except paragraph (a)(1) are hereby

§60.742(b)(2) or §60.742(c), respectively. (b) Any notice under paragraph (a) of this section shall be published only after public notice and an opportunity for a public hearing. (c) Any person seeking permission under this section shall submit to the Administrator either results from an emission test that

(a) Beginning October 1, 2007, owners and operators of stationary CI ICE subject to this subpart that use diesel fuel must use diesel fuel that meets the requirements of 40 CFR 80.510(a). (b) Beginning October 1, 2010, owners and operators of stationary CI ICE subject to this subpart with a displacement of less than 30 liters per cylinder that use diesel fuel must use diesel fuel that meets the requirements of 40 CFR 80.510(b) for

stationary SI ICE with a maximum engine power less than or equal to 30 KW (40 HP) with a total displacement less than or equal to 1,000 cc to the certification emission standards and other requirements for new nonroad SI engines in 40 CFR part 90 or 40 CFR part 1054, and manufacturers of stationary SI emergency engines that are greater than 25 HP and less than 130 HP who meet the Phase 1 emission standards in 40 CFR 90.103, applicable to class II engines, must certify their stationary SI ICE using the

stationary SI ICE with a maximum engine power less than or equal to 30 KW (40 HP) with a total displacement less than or equal to 1,000 cc to the certification emission standards and other requirements for new nonroad SI engines in 40 CFR part 90 or 40 CFR part 1054, and manufacturers of stationary SI emergency engines that are greater than 25 HP and less than 130 HP who meet the Phase 1 emission standards in 40 CFR 90.103, applicable to class II engines, must certify their stationary SI ICE using the

(a) Title of Plan. Commonwealth of Virginia State Implementation Plan under section 111(d) plan for the Designated Facility—Kraft Pulp Mills. (b) The plan was officially submitted by the Executive Director of the Department of Virginia Department of Air Pollution Control, on May 15, 1990. (c) Identification of sources. The Plan includes the following Kraft Pulp

unit. (c) If you own or operate an SSI unit(s) and make physical or operational changes to the SSI unit(s) for which construction commenced on or before September 21, 2011 primarily to comply with the federal plan, 40 CFR part 60, subpart LLLL, does not apply to the unit(s). Such changes do not qualify as modifications under 40 CFR part 60, subpart LLLL.

(a) Each owner or operator of a bulk gasoline terminal or pipeline breakout station subject to the provisions of this subpart shall equip each gasoline storage vessel with a design capacity greater than or equal to 75 m3 according to the requirements in §60.112b(a) (1) through (4) of this chapter, except for the requirements in

treatment and controls as an agent for the industrial user. Group 1 POTW treatment plant is defined in §63.1595. (b) Your POTW is a Group 2 POTW treatment plant if your POTW treats wastewater that is not subject to control by another NESHAP or the industrial user does not comply with its NESHAP by using the treatment and controls located at your POTW treatment plant. “Group

Compliance is determined using performance testing, collection system monitoring, continuous parameter monitoring, and other credible evidence. In addition, continuous parameter monitoring data collected under §63.1961(b)(1), (c)(1), and (d) are used to demonstrate compliance with the operating standards for control systems. If a deviation occurs, you have failed to

Open Table For each .  .  . During this time frame .  .  . You must comply with the emission limitations in Table 1 to this subpart using the .  .  .

§63.5758. Keep records of the organic HAP content determination. (b) For solvents containing more than 5 percent organic HAP by weight, comply with the requirements in paragraph (b)(1) or (b)(2), and paragraph (b)(3) of this section. (1) If you are using an enclosed spray gun cleaner, visually inspect it at least once per month to ensure that covers are in place and the covers have no visible gaps when the cleaner is

(a) You must monitor and collect data according to this section. (b) Before September 9, 2020, except for monitor malfunctions, associated repairs, and required quality assurance or control activities (including, as applicable, calibration checks and required zero and span adjustments), you must monitor continuously (or collect data at all required intervals) at all times that the affected source is operating including periods of

a reasonable basis in law and in fact for making the determination.

allowances allocated for the year after the year in which the source has excess emissions, from the source's compliance account on a first-in, first-out basis in accordance with §73.35(c)(2) of this chapter, equal to the amount of the source's excess emissions of sulfur dioxide. [58 FR 3757, Jan. 11, 1993, as amended at 70 FR 25337, May 12, 2005]

(a) The Presiding Officer will review and evaluate the record, including the proposed findings and conclusions and any briefs filed by the parties, and issue a proposed decision on the factual, policy, and legal issues referred by the Environmental Appeals Board for decision under §78.6(b)(2)(ii) of this part, accompanied by findings of fact and proposed conclusions of

would be willing to review the record and discuss it with the individual. (2) The availability of the record may be subject to any procedures for disclosure to an individual of medical records about himself under part 20 of this chapter, in addition to or in lieu of the procedures in paragraph (b)(1), that are not inconsistent with §21.41(f).

(a) A Joint Sectoral Committee is set up to monitor the activities under both the transitional and operational phases of this subpart. (b) The Joint Sectoral Committee will be cochaired by a representative of the Food and Drug Administration (FDA) for the United States and a representative of the European Community (EC) who each will have one vote. Decisions will be taken by unanimous consent. (c) The

derived. (b) For a given product or sector, the provisions contained in subparts A and B of this part shall apply in the first place, and the provisions of subpart C of this part in addition to those provisions. In the case of any inconsistency between the provisions of subpart A or B of this part and subpart C of this part, subpart A or B shall prevail, to the extent of that inconsistency. (c) The agreement from which this part is

paragraph (a) of this section may be used as a color additive in contact lens in amounts not to exceed the minimum reasonably required to accomplish the intended coloring effect. (2) Authorization for this use shall not be construed as waiving any of the requirements of section 510(k), 515, and 520(g) of the Federal Food, Drug, and Cosmetic Act with respect to the contact lens in which the color additive is used. (c)

For the purposes of this part: (a)-(f) [Reserved] (g) The term alumina means a suspension in water of precipitated aluminum hydroxide. (h) The term blanc fixe means a suspension in water of precipitated barium sulfate. (i) The term

which is formed as follows: (1) The listed name of the color from which the lake is prepared; (2) The name of the basic radical combined in such color; and (3) The word “Lake”. (For example, the name of a lake prepared by extending the aluminum salt prepared from FD&C Blue No. 1 upon the substratum would be FD&C Blue No. 1—Aluminum Lake.)

Director of the appropriate Food and Drug Administration district office. After normal business hours (8 a.m. to 4:30 p.m.), the Food and Drug Administration's emergency number, 1-866-300-4374 shall be used. The manufacturer shall promptly send written confirmation of the notification to the Food and Drug Administration, Center for Food Safety and Applied Nutrition, Office of Compliance, Division of Enforcement (HFS-605), Recall Coordinator, 5001 Campus Dr., College Park, MD 20740, and to the

(a) Sorghum sirup is the liquid food derived by concentration and heat treatment of the juice of sorghum cane (sorgos) (Sorghum vulgare). It contains not less than 74 percent by weight of soluble solids derived solely from such juice. The concentration may be adjusted with or without added water. It may contain one or more of the optional ingredients provided for in paragraph (b) of this section. All ingredients from which the

plant or animal used as the source; and (iii) Any known toxicants that could be in the source; (b) A description of the method of manufacture of the notified substance in sufficient detail to evaluate the safety of the notified substance as manufactured; (c) Specifications for food-grade material; and (d) When necessary to demonstrate safety, relevant data and