(a) Regional Haze. The requirements of section 169A of the Clean Air Act are not met because the regional haze plan submitted by Indiana on January 14, 2011, and supplemented on March 10, 2011, does not include fully approvable measures for meeting the requirements of 40 CFR 51.308(d)(3) and 51.308(e) with respect to emissions of NOX and SO

legal authority to establish and implement a compliance advisory panel and to have a fully operational PROGRAM by November 15, 1994. (i) Incorporation by reference. (A) Letter from the Massachusetts Department of Environmental Protection dated November 13, 1992 submitting a revision to the Massachusetts State Implementation Plan. (B) State Implementation Plan Revision for a Small Business

Grinder means a unit which is used to pulverize dry phosphate rock to the final product size used in the manufacture of phosphate fertilizer and does not include crushing devices used in mining. (f) Ground phosphate rock handling and storage system means a system which is used for the conveyance and storage of ground phosphate rock from grinders at phosphate rock plants.

report to the Administrator within 30 days whenever extruded fiber for the preceding 12 calendar months exceeds 500 Mg (551 ton). (c) The requirements of this section remain in force until and unless EPA, in delegating enforcement authority to a State under section 111(c) of the Act, approves reporting requirements or an alternate means of compliance surveillance adopted by such State. In that event, affected sources within the State will be relieved of the obligation

process unit is an affected facility. (b) Any affected facility under paragraph (a) of this section that commences construction, reconstruction, or modification after January 20, 1984, and on or before August 23, 2011, is subject to the requirements of this subpart. (c) Addition or replacement of equipment (defined in §60.631) for the

material(s) and solid waste(s) the CISWI is currently combusting and has combusted over the past 6 months, and the fuel(s) or non-waste materials the unit will commence combusting; (4) The date on which you became subject to the currently applicable emission limits; and (5) The date upon which you will cease combusting solid waste, and the date (if different) that you intend for any new requirements to become applicable (

§60.2916 and table 2 of this subpart. (2) Approval of petitions for specific operating limits in §60.2917. (3) Approval of major alternatives to test methods. (4) Approval of major alternatives to monitoring. (5) Approval of

(a) Letter from the New Hampshire Department of Environmental Services (NH DES), submitted November 14, 2017, requested delegation of authority from the EPA to implement and enforce the Federal Plan Requirements for Sewage Sludge Incineration Units Constructed on or before October 14, 2010 (SSI Federal Plan). The SSI Federal Plan will be administered by both the NH DES and the EPA pursuant to 40 CFR part 62 subpart LLL. (b)

(a) Identification of plan. Texas Plan for Control of Designated Pollutants from Existing Facilities (111(d)Plan). (b) The plan was officially submitted as follows: (1) Control of sulfuric acid mist from existing sulfuric acid production plants as adopted by the Texas Air Control Board (TACB) on May 12, 1989, and submitted by the Governor in a letter dated

the closed vent system and nonflare control devices to reduce emissions of regulated material with an efficiency of 95 percent or greater or to reduce emissions of regulated material to a concentration of 20 parts per million by volume or, for an enclosed combustion device, to provide a minimum of 760 °C (1400 °F). Owners and operators of closed vent systems and nonflare control devices used to comply with this subpart shall comply with the provisions of subpart SS of this part, except as provided

and schedule requirements in §63.1454. Several of these notifications must be submitted before the compliance date for your affected source.

§63.1545(a), each owner or operator of an existing primary lead processor must continue to comply with the requirements of §§63.1543 and 63.1544 as promulgated in the June 4, 1999 NESHAP for Primary Lead Smelting. (d) Each owner or operator of an existing primary lead processor must comply with the requirements of

compliance options, operating requirements, and work practice requirements do not apply during times when the process unit(s) subject to the compliance options, operating requirements, and work practice requirements are not operating, or during periods of startup, shutdown, and malfunction. Startup and shutdown periods must not exceed the minimum amount of time necessary for these events. (b) You must always operate and maintain your affected source, including air

Open Table For each of the following process units .  .  . You must comply with one of the following six compliance options by using an emissions control system .  .  .

Open Table For the following process units at existing or new affected sources .  .  . You must .  .  . (1) Dry rotary dryers

on an annual basis, an existing emergency stationary RICE, or an existing limited use stationary RICE. If you own or operate any of the following RICE with a site rating of more than 500 brake HP located at a major source of HAP emissions, you do not need to comply with the requirements in the General Provisions specified in Table 8 except for the initial notification requirements: A new stationary RICE that combusts landfill gas or digester gas equivalent to 10 percent or more of the gross heat

For the .  .  . You have demonstrated initial compliance if .  .  . 1. CO or THC concentration emission limitation The first 4-hour rolling average CO or THC concentration is 20 ppmvd or less, corrected to 15 percent O2 content if CEMS are installed

(e) You must meet the notification and schedule requirements in §63.9640. Several of these notifications must be submitted before the compliance date for your affected source.

and schedule requirements in §63.9930. Several of these notifications must be submitted before the compliance date for your affected source.

. Secondary copper smelter means a facility that processes copper scrap in a blast furnace and converter or that uses another pyrometallurgical purification process to produce anode copper from copper scrap, including low-grade copper scrap. A facility where recycled copper scrap or copper alloy scrap is melted to produce ingots or for direct use in a manufacturing process is not a secondary copper smelter.

order or decree is terminated or revoked, or the inability to comply ceases to be for reasons entirely beyond the control of the source owner or operator as defined in §66.31(c). (c) Exemptions granted pursuant to §66.32 or

(a) The owner or operator shall ensure that each employee presently operating a process, and each employee newly assigned to a covered process have been trained or tested competent in the operating procedures provided in §68.52 that pertain to their duties. For those employees already operating a process on June 21, 1999, the owner or operator may certify in writing that

reports shall be retained for five years. [61 FR 31721, June 20, 1996, as amended at 82 FR 4699, Jan. 13, 2017; 84 FR 69914, Dec. 19, 2019]

(a) Eligibility. A unit is eligible for allowance allocations under this section if it meets the following requirements: (1) It is an existing unit that is a utility unit; (2) It serves a generator with nameplate capacity equal to or greater than 75 MWe; (3) Its 1985 actual SO2

section does not: (1) Permit a statement of differences of opinion with respect to warnings (including contraindications, precautions, adverse reactions, and other information relating to possible product hazards) required in labeling for food, drugs, devices, cosmetics, or tobacco products under the Federal Food, Drug, and Cosmetic Act. (2) Permit a statement of differences of opinion with respect to the effectiveness of a drug

(a) This section applies when a Federal, State, or local court holds in abeyance, or refers to the Commissioner, any matter for an initial administrative determination under §10.25(c) or §10.45(b). (b) The Commissioner shall promptly agree or

(1) Seminars designed to inform the parties and CAB's about each party's regulatory system, procedures, and requirements; (2) Workshops designed to provide the parties with information regarding requirements and procedures for the designation and surveillance of CAB's; (3) Exchange of information about reports prepared during the transition period; (4) Joint training exercises

(a) Except where the petition involves a new drug, the Commissioner, within 15 days after receipt, will notify the petitioner of acceptance or nonacceptance of a petition, and if not accepted the reasons therefor. If accepted, the date of the notification letter sent to petitioner becomes the date of filing for the purposes of section 721(d)(1) of the act. If the petitioner desires, he may supplement a deficient petition after being notified regarding deficiencies

(c) Labeling. The label of the color additives shall conform to the requirements of §70.25 of this chapter. (d) Exemption from certification. Certification of these color additives is not necessary for the protection of the public health and therefore the color additives are exempt from the

(c) Labeling. The label of the color additive shall conform to the requirements of §70.25 of this chapter. (d) Exemption from certification. Certification of this color additive is not necessary for the protection of the public health, and therefore the color