40 CFR §63.8390

1. (a)This subpart applies to each existing, new, or reconstructed affected source at a BSCP manufacturing facility.
2. (b)For the purposes of this subpart, the affected sources are described in paragraphs (b)(1) and (2) of this section.
   1. (1)All tunnel kilns at a BSCP manufacturing facility are an affected source. For the remainder of this subpart, a tunnel kiln with a design capacity equal to or greater than 9.07 megagrams per hour (Mg/hr) (10 tons per hour (tph)) of fired product will be called a large tunnel kiln, and a tunnel kiln with a design capacity less than 9.07 Mg/hr (10 tph) of fired product will be called a small tunnel kiln.
   2. (2)Each periodic kiln is an affected source.
3. (c)Process units not subject to the requirements of this subpart are listed in paragraphs (c)(1) through (4) of this section.
   1. (1)Kilns that are used exclusively for setting glazes on previously fired products are not subject to the requirements of this subpart.
   2. (2)Raw material processing and handling.
   3. (3)Dryers.
   4. (4)Sources covered by subparts KKKKK and SSSSS of this part.
4. (d)A source is a new affected source if construction of the affected source began after December 18, 2014, and you met the applicability criteria at the time you began construction.
5. (e)An affected source is reconstructed if you meet the criteria as defined in § 63.2.
6. (f)An affected source is existing if it is not new or reconstructed.