40 CFR Table 6
Requirements for Reports
June 9, 2020
As stated in §63.8818(a), you must submit a compliance report that includes the information in §63.8818(e) through (g) as well as the information in the following table. Rows 1 and 3 of the following table apply to loop slitter affected sources. Rows 1 through 5 apply to flame lamination affected sources. You must also submit startup, shutdown, and malfunction reports according to the requirements in the following table if you own or operate a new or reconstructed flame lamination affected source.
Open Table
If . . . | Then you must submit a report or statement that . . . |
---|---|
1. There are no deviations from any emission limitations that apply to you | There were no deviations from the emission limitations during the reporting period. |
2. There were no periods during which the operating parameter monitoring systems were out-of-control in accordance with the monitoring plan | There were no periods during which the CPMS were out-of-control during the reporting period. |
3. There was a deviation from any emission limitation during the reporting period | Contains the information in §63.8818(e)(5). |
4. There were periods during which the operating parameter monitoring systems were out-of-control in information in accordance with the monitoring plan | Contains the information in §63.8818(f)(3). |
5. There was a startup, shutdown, or malfunction where the source did not meet the emission limitations set out in §63.8790 at a new or reconstructed flame lamination affected source during the reporting period that is not consistent with your startup, shutdown, and malfunction plan. | Contains the information in §63.8818(i). |