(a) All percentages shall be calculated on the basis of weight.

(b) In order to allow for variations incident to proper sizing and handling, tolerances shall be permitted for the respective size classifications as indicated in Table III:

Table III

[Percent]

Open Table
Size classification Tolerances for size
Smaller than three-fourths halves Will not pass through 2464 inch round hole Pass through 2464 inch round hole Pass through 1664 inch round hole Pass through 864 inch round hole
Halves 5 1 (included in 5 percent)
Pieces and halves1 18 3 (included in 18 percent) 1 (included in 2 percent).
Pieces 25 5 (included in 25 percent) 1 (included in 5 percent).
Small pieces2 10 2.

1No part of any tolerance shall be used to reduce the percentage of halves required or specified in a lot of “pieces and halves”.

2The tolerances of 10 percent and 2 percent for “small pieces” classification shall apply, respectively, to any smaller maximum or any larger minimum sizes specified.


Tried the LawStack mobile app?

Join thousands and try LawStack mobile for FREE today.

  • Carry the law offline, wherever you go.
  • Download CFR, USC, rules, and state law to your mobile device.